P.O. Box 14572, Scottsdale, AZ. 85267. Tel: 480-258-1050
New Product SHOWCASE from
Mac's Modeling,LLC.
updated 11/29/2013
This page is just to showcase a new product.
New from
(Click on the thumbnails to enlarge the pictures.)
Front
brake ducts for the 1:12 McLaren M23, 1976.
After producing the brake ducts as "2 piece" parts, it was discovered they
were too long. They have been redesigned and are now "1 piece" parts.
This is
the first half of the new mold with the master in place.
and the first new set
ready to be removed.
This is
how they look when removed from the mold
You will receive them looking like this.
You will need to clean them up (removed the
casting flash and lines)
They
have been produced with a recess at the inlet, as you can see.
You can (if you think it necessary) increase the
depth of the recess.
These will
fit directly on the kit upright
without any modification.
The metal on top of the upright ball, is the insert ball joint, from the upper
A-arm AZMP M23 7576, with the "finest" piece of wire holding it together.
This was
the hardest shot to take
As the lower A-Arms have not arrived yet, I had to dry assemble the front
"fire wall", upper A-Arm attached to the wheel upright, placed in a modified
body, so you can see the clearance of the brake duct from the floor. Your
finished car will obviously look better than this. ;)
Send your order to orders@macsmodeling.com, put AZRM in the subject line and how many you would like in the body of the email, or use the order form and send it to the same email address, the same way.
Mac
Links to previous Showcase items.
AZRM
M23 1218 Short nose and wings, plus AZMP M23 1210 front bulkhead/firewall
AZMP M23 1208 Narrow nose for 1:12
Tamiya M23
AZMW12001 Wheels for 1:12 Tamiya Ferrari 312B
AZRM 1:12 Mesh Velocity Stack
covers
Scale
Spark plug wire
CRAFT1O
figures
ICON Automotive miniatures, Rain tires
AZRM 1:20 scale
Anodized wheels
AZRM colored heat shrink tubing
1:12 scale Motorcycle chains
1:12 scale Motorcycle
figures